Adding a laser sensor to your BRNKL installation is simple. The following connections are required:

  1. Blue wire connects to a common ground.
  2. Black wire must connect to Pin 9 (shore power) in the BRNKL connector.
  3. Brown wire connects to a 12V source, which is commonly Pin 10 (battery 1) in the BRNKL connector.
  4. The supplied 1k ohm resistor must be wired between Pin 9 and a 12V source. In this example, the 12V source is wired into Pin 10, which would normally be the House Battery connection.
Did this answer your question?